Visit our main site at www.dashboardpws.com

Orders placed as of May 22, 2022 will start shipping in MID TO LATE JUNE.


Use our patented, pivoting guide rail brackets to secure your track saw guide
rail for accurate crosscuts. Each set consists of TWO BRACKETS: ONE FRONT and
ONE REAR. The rear bracket is the one that pivots.

The design accommodates 4 types of guide rails:
1. Festool/Makita style
2. Dewalt
3. Bosch/Mafell
4. Kreg

*****YOU MUST INCLUDE A NOTE about which type of saw/rail and table you use so
we can include the correct hardware.

Your guide rail attaches securely with no tools and slides on and off in
seconds. Our brackets allow you to cut materials from 0mm to 72mm thick. A
precisely machined locating pin in the non-pivoting side fits perfectly into
your guide rail’s bottom slot to arrange the track for reliable accuracy. The
brackets are shown on our Dash-Board®️Portable Workshop website
(www.dashboardpws.com) and on Instagram

As a rail's slot width can vary slightly from brand to brand, we include a
special Pinsert™ for your guide rail that mates perfectly with our locating pin.

Our brackets are compatible with three mounting arrangements:

1. Standard T track on a shop-built table. If you choose to build your table
with standard T track, let us know exactly which track and we'll provide simple
instructions for
positioning it. We recommend buying yours from Orange Aluminum.

2. The Festool MFT3

3. A table you build using 8020-style T-slot extrusions. Tell us which profile
you're using.


PLEASE NOTE: Messages from us to you via Etsy often go right into spam folders
and we end up wondering where customers have gone. PLEASE PROVIDE YOUR EMAIL
ADDRESS so we can confirm your order and ask questions/update you from rob
[!at] dashboardpws.com for smoother communication.